openocd.git
2019-02-21 Armin van der... Fix support for single-bank stm32l4 processors 13/4913/3
2019-02-19 Oleksij Rempelftdi: use "adapter usb location" instead of ftdi_locati... 71/4771/10
2019-02-15 Tomas Vanektarget, breakpoints: improve error handling 71/4871/4
2019-02-14 Oleksij Rempeldoc: fix typo in "adapter usb location" command 07/4907/3
2019-02-14 Tomas Vanekdoc/openocd.texi: fix xref warning 05/4905/2
2019-02-14 Marc Schinktarget/riscv-011: Fix memory leak in handle_halt_routine() 84/4884/2
2019-02-07 Marc Schinkjlink: Use correct SWD buffer size 78/4878/2
2019-02-07 Antonio Borneodrivers/bitbang: remove unused extern declaration of... 74/4874/2
2019-02-07 Antonio Borneocommand: fix the mode for command "jtag configure" 86/4886/2
2019-02-07 Oleksij Rempeldoc: add documentation for "adapter usb location" command 69/4769/7
2019-02-07 Tomas Vanektarget/cortex_m: fix clang static analyzer warning 81/4881/3
2019-02-07 Tomas Vanektarget/hla_target: fix clang static analyzer warning 82/4882/3
2019-02-07 Kevin Vermilionat91samd: Add flash programming support for SAMC2?N... 80/4880/4
2019-02-07 Jean-Christian... target start_algorithm: Don't copy the IN mem_params... 11/4811/4
2019-02-07 Jan Vojtechflash/nor/stm32f1x: Ability to change user option bytes. 63/4663/5
2019-02-07 Tomas Vanektarget algo: do not write reg_param if direction is... 13/4813/2
2019-02-07 Antonio Borneodrivers/imx_gpio: fix polarity of srst and trst 47/4847/2
2019-02-07 Oleksij Rempeljtag: drivers: provide initial support for usb path... 80/4580/14
2019-02-05 Tomas Vanekflash/nor: flash driver and cfg for SAM E54, E53, E51... 72/4272/6
2019-02-04 Tomas Vanekflash/nor/stm32f1x: use address instead of offset in... 59/4859/3
2019-02-04 Tomas Vanekflash/nor/stm32f1x: fix minor error messages 58/4858/2
2019-02-04 Tomas Vanekcortex_m: fix stepping on FPB rev 1 57/4857/2
2019-02-04 Guillaume Revaillotflash/nor/at91samd: add samr34j18. 72/4872/2
2019-01-30 Antonio Borneoarm_adi_v5: rewrite dap_to_jtag and dap_to_swd 52/4852/3
2019-01-30 Matthias Welwarskyaarch64: support for aarch32 ARM_MODE_SYS 94/4494/3
2019-01-27 Tomas Vanektarget: do not allow 'target create' after init 42/4842/2
2019-01-27 Tomas Vanekcommand: check command mode for native jim commands 41/4841/2
2019-01-27 Tomas Vanektarget/cortex_m: inform if an external reset occurs 40/4840/3
2019-01-27 Tomas Vanekcommand: Log the failed command by full name 37/4837/3
2019-01-27 Tomas Vanekhla_target: fix adapter_poll() to preserve TARGET_DEBUG... 20/4820/2
2019-01-27 Antonio Borneocommand: initialize the command mode for every command 61/4861/2
2019-01-26 Peter Lawrencetcl: Support for Analog Devices ADSP-SC58x / ADSP-SC584... 55/4855/4
2019-01-23 Antonio Borneojtag: cmsis-dap: use macro SWJ_PIN_SRST in place of... 46/4846/2
2019-01-23 Moritz Fischerrtos: Add RTOS task awareness for Chromium-EC 85/4685/10
2019-01-23 Jonathan McDowellCorrect ZynqMP configuration to be appropriately named 50/4850/2
2019-01-23 Antonio Borneoarm_opcode: fix encoding of ARMv5 breakpoint instruction 54/4854/2
2019-01-23 Antonio Borneoarm_adi_v5: fix and update sequences to spec IHI 0031E 51/4851/2
2019-01-23 Tomas Vanektarget/arm_dap: fix segmentation fault in 'dap info... 60/4860/2
2019-01-21 Mirko Vogtnrf5: add nrf5 device definition for HWID 0x00E3 45/4845/3
2019-01-16 Tarek BOCHKATIcortex_m: fix bug in poll() machine state (external... 17/4817/8
2019-01-16 Tarek BOCHKATIcortex_a_poll: minor code factorization to enhance... 32/4832/4
2019-01-16 Severin Junkerat91samd: added SAM-DA1 parts 35/4835/3
2019-01-16 Antonio Borneohelper/command: check for malloc failure in __command_name 38/4838/3
2019-01-14 Tomas Vanektarget/stm8: add missing destroy_reg_param() 14/4814/2
2019-01-14 Antonio Borneodrivers/sysfsgpio: fix usage messages 33/4833/2
2019-01-11 Tim NewsomeAdd flash support for SiFive's Freedom E platforms 56/4656/7
2019-01-08 Austin Phillipsstlink_usb: Submit multiple USB URBs at once to improve... 84/4484/5
2019-01-08 Antonio Borneolibusb: add debug message on adapter not found due... 01/4701/3
2019-01-08 Antonio Borneojtag/drivers/usb_common: return oocd error values 99/4699/3
2019-01-08 Antonio Borneolibusb0: return oocd error values 98/4698/3
2019-01-08 Antonio Borneotarget/aarch64: add support for multi-architecture gdb 55/4755/2
2019-01-08 Antonio Borneotarget/arm: add support for multi-architecture gdb 54/4754/2
2019-01-08 Antonio Borneotarget/stm8: add support for multi-architecture gdb 53/4753/2
2019-01-08 Cody P Schaferarmv7m: always set xPSR.T=1 when starting an algorithm 58/4658/7
2019-01-08 Edward Fewellicepick.cfg: add cancel reset bit to TAP register writes 89/4789/2
2019-01-08 Edward Fewelldrivers: xds110: Add support for XDS110 stand-alone... 93/4793/2
2019-01-08 Jerome ForissierHACKING: add note about refs/for/master 06/4806/4
2019-01-08 Jerome ForissierHACKING: replace refs/publish/master with refs/for... 10/4810/3
2019-01-02 Rod BoyceNOR: lpc2000 Add support for LPC84x devices 84/4684/10
2019-01-02 Oleksij Rempelflash: nor: ath79: remove base calculation 21/4821/3
2019-01-02 Jānis Skujenieksflash/nor/nrf5: set correct timeout for nvmc operations 22/4822/2
2018-12-27 Tarek BOUCHKATItarget/arm_cti : export CTI APPPULSE and INACK register 15/4815/2
2018-12-27 Tarek BOCHKATItarget/arm_cti: add debug message when an incorrect... 16/4816/2
2018-12-25 Jean-Christian... command: Log the failed command name 08/4808/3
2018-12-23 Jean-Christian... Add LPC8Nxx and NHS3xx support. 15/4515/17
2018-12-21 Simon Qianadd w600 support 01/4801/6
2018-12-19 Tomas Vanekflash/nor/spi: add adesto AT25DF081A 02/4802/2
2018-12-19 Tomas Vanektarget: allow moving and resizing working area on runni... 97/4797/3
2018-12-19 Tomas Vanektarget: move all working_area functions to one block 96/4796/2
2018-12-19 Tomas Vanektarget/cortex_m: fix cortex_m reset_config help and... 95/4795/2
2018-12-19 Tomas Vanektarget/cortex_m: do not use VECTRESET on Cortex-M0... 94/4794/4
2018-12-18 Liming Suntarget: armv8: Add TARGET_HALTED check for gdb connect 58/4758/3
2018-12-18 Antonio Borneotarget/cortex_a: enable DSCR_HALT_DBG_MODE during examine 83/4783/2
2018-12-17 YanLin Zhuadi_v5_jtag: fix build break when open DEBUG_WAIT macro 04/4804/2
2018-12-15 Antonio Borneohelper/startup.tcl: fix execution stack frame of wrappe... 31/4731/2
2018-12-12 Bohdan Tymkivflash/nor/core: Fix chunk size calculation in default_f... 85/4785/2
2018-12-12 Steven Stallionflash/esirisc: refactor register write protection 91/4791/4
2018-12-12 Steven Stallionesirisc: support eSi-Trace 80/4780/7
2018-12-12 Jiri Kastnerfix cc32xx related changes 92/4792/2
2018-12-12 Antonio Borneoarmv7a_mmu: s/LOG_ERROR/LOG_WARNING/ on address transla... 02/4602/3
2018-12-11 Antonio Borneolibusb0: add compatibility define for transfer type... 00/4700/3
2018-12-11 bobflash/nor: Add support for sector erase in stm32l4x... 77/4777/6
2018-12-11 Edward Fewellflash/nor: update cc3220sf for issue found in code... 88/4788/2
2018-12-11 Edward Fewellflash/nor: update CC26xx/CC13xx support 87/4787/2
2018-12-11 Reto Schneiderjtag: sysfsgpio: clean up swd gpios 84/4784/2
2018-12-11 Antonio Borneohelper/log: remove dead code in log_forward() 79/4779/2
2018-12-11 Tomas Vanekjtag: cmsis-dap: developer tool - enter a command by... 03/3103/2
2018-12-06 Spencer Oliverdoc: add ARMv6-M info regarding TAP Declaration 82/4782/2
2018-12-06 Antonio Borneodoc: fix some typo about STMicroelectronics name 18/4718/2
2018-12-06 Antonio Borneostlink: add support for STLINK-V3 17/4717/3
2018-12-06 Antonio Borneostlink: fix printed version for new STM8 nucleo board 16/4716/3
2018-12-06 Antonio Borneostlink: dump version in the same format of ST firmware... 15/4715/3
2018-12-06 Antonio Borneostlink: add STLINK_F_HAS_GETLASTRWSTATUS2 14/4714/2
2018-12-06 Antonio Borneostlink: remove reset pulse when entering in JTAG 13/4713/2
2018-12-06 Antonio Borneostlink: simplify api version handling 12/4712/2
2018-12-06 Antonio Borneostlink: add STLINK_F_HAS_MEM_16BIT 11/4711/3
2018-12-06 Antonio Borneostlink: add STLINK_F_HAS_JTAG_SET_FREQ 10/4710/3
2018-12-06 Antonio Borneostlink: add STLINK_F_HAS_SWD_SET_FREQ 09/4709/3
2018-12-06 Antonio Borneostlink: add STLINK_F_HAS_TARGET_VOLT 08/4708/3
2018-12-06 Antonio Borneostlink: add STLINK_F_HAS_TRACE 07/4707/2
next