AT91SAM4L: handle reset run/halt in SMAP

[openocd.git] / tcl / target / samsung_s3c2410.cfg

diff --git a/tcl/target/samsung_s3c2410.cfg b/tcl/target/samsung_s3c2410.cfg
index 73d3b50039182dbf1c71323febb3b9e897d45e3e..017c104927e25ac31e5bd64fa3e331d236630923 100644 (file)
--- a/tcl/target/samsung_s3c2410.cfg
+++ b/tcl/target/samsung_s3c2410.cfg
@@ -1,23 +1,23 @@
 # Found on the 'TinCanTools' Hammer board.
 
 if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
+   set _CHIPNAME $CHIPNAME
 } else {
-   set  _CHIPNAME s3c2410
+   set _CHIPNAME s3c2410
 }
 
 if { [info exists ENDIAN] } {
-   set  _ENDIAN $ENDIAN
+   set _ENDIAN $ENDIAN
 } else {
   # This config file was defaulting to big endian..
-   set  _ENDIAN little
+   set _ENDIAN little
 }
 
 if { [info exists CPUTAPID] } {
-   set  _CPUTAPID $CPUTAPID
+   set _CPUTAPID $CPUTAPID
 } else {
    # Force an error until we get a good number.
-   set  _CPUTAPID 0xffffffff
+   set _CPUTAPID 0xffffffff
 }
 
 #use combined on interfaces or targets that cannot set TRST/SRST separately
@@ -27,7 +27,7 @@ reset_config trst_and_srst
 jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
 
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME arm920t -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm920t
+target create $_TARGETNAME arm920t -endian $_ENDIAN -chain-position $_TARGETNAME
 
 $_TARGETNAME configure -work-area-phys 0x30800000 -work-area-size 0x20000 -work-area-backup 0