Olimex SAM9-L9260 board configuration update.

[openocd.git] / tcl / board / telo.cfg

diff --git a/tcl/board/telo.cfg b/tcl/board/telo.cfg
index 29066f960668e49fa9e9a3f4fa161ec84a2ec68b..0cbdb816d9ec85a4fb1aabf43a4dbcb91fcbcc32 100644 (file)
--- a/tcl/board/telo.cfg
+++ b/tcl/board/telo.cfg
@@ -1,17 +1,17 @@
-source [find c100.cfg]
+source [find target/c100.cfg]
 # basic register defintion for C100
-source [find c100regs.tcl]
+source [find target/c100regs.tcl]
 # board-config info
-source [find c100config.tcl]
+source [find target/c100config.tcl]
 # C100 helper functions
-source [find c100helper.tcl]
+source [find target/c100helper.tcl]
 
 
 # Telo board & C100 support trst and srst
 # Note that libftd2xx.so tries to assert srst
 # which break this script
 # use libftdi.so library instead with this script
-# make the reset asserted to 
+# make the reset asserted to
 # allow RC circuit to discharge for: [ms]
 jtag_nsrst_assert_width 100
 jtag_ntrst_assert_width 100
@@ -39,7 +39,7 @@ $_TARGETNAME configure -event reset-deassert-post {
        # Force target into ARM state.
 #      soft_reset_halt # not implemented on ARM11
        puts "Detected SRSRT asserted on C100.CPU"
-       
+
 }
 
 $_TARGETNAME configure -event reset-assert-post {
@@ -47,14 +47,15 @@ $_TARGETNAME configure -event reset-assert-post {
   #sleep 10
 }
 
-proc power_restore {} { puts "Sensed power restore. No action." } 
+proc power_restore {} { puts "Sensed power restore. No action." }
 proc srst_deasserted {} { puts "Sensed nSRST deasserted. No action." }
 
 
 # boots from NOR on CS0:  8 MBytes CFI flash, 16-bit bus
 # it's really 16MB but the upper 8mb is controller via gpio
 # openocd does not support 'complex reads/writes' to NOR
-flash bank cfi 0x20000000 0x01000000 2 2 $_TARGETNAME
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME cfi 0x20000000 0x01000000 2 2 $_TARGETNAME
 
 # writing data to memory does not work without this
 memwrite burst disable
\ No newline at end of file