tcl/target/ti_k3: Add AM273 SoC

[openocd.git] / tcl / target / npcx.cfg

# SPDX-License-Identifier: GPL-2.0-or-later

# script for Nuvoton NPCX Cortex-M4 Series

# Adapt based on what transport is active.
source [find target/swj-dp.tcl]

# Set Chipname
if { [info exists CHIPNAME] } {
        set _CHIPNAME $CHIPNAME
} else {
        set _CHIPNAME npcx
}

# SWD DAP ID of Nuvoton NPCX Cortex-M4.
if { [info exists CPUDAPID ] } {
   set _CPUDAPID $CPUDAPID
} else {
   set _CPUDAPID 0x4BA00477
}

# Work-area is a space in RAM used for flash programming
# By default use 32kB
if { [info exists WORKAREASIZE] } {
   set _WORKAREASIZE $WORKAREASIZE
} else {
   set _WORKAREASIZE 0x8000
}

if { [info exists FIUNAME]} {
   set _FIUNAME $FIUNAME
} else {
   set _FIUNAME npcx.fiu
}

# Debug Adapter Target Settings
swj_newdap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUDAPID
dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME cortex_m -endian little -dap $_CHIPNAME.dap

$_TARGETNAME configure -work-area-phys 0x200c0000 -work-area-size $_WORKAREASIZE -work-area-backup 0

# Initial JTAG/SWD speed
# For safety purposes, set for the lowest cpu clock configuration
# 4MHz / 6 = 666KHz, so use 600KHz for it
adapter speed 600

# For safety purposes, set for the lowest cpu clock configuration
$_TARGETNAME configure -event reset-start {adapter speed 600}

# use sysresetreq to perform a system reset
cortex_m reset_config sysresetreq

# flash configuration
set _FLASHNAME $_CHIPNAME.flash
flash bank $_FLASHNAME npcx 0x64000000 0 0 0 $_TARGETNAME $_FIUNAME