tcl/board/osk5912.cfg

   1 # SPDX-License-Identifier: GPL-2.0-or-later
   2
   3 # http://omap.spectrumdigital.com/osk5912/
   4
   5 source [find target/omap5912.cfg]
   6
   7 # NOTE: this assumes you're using the ARM 20-pin ("Multi-ICE")
   8 # JTAG connector, and accordingly have J1 connecting pins 1 & 2.
   9 # The TI-14 pin needs "trst_only", and J1 connecting 2 & 3.
  10 reset_config trst_and_srst separate
  11
  12 # NOTE:  boards with XOMAP parts wire nSRST to nPWRON_RESET.
  13 # That resets everything -- including JTAG and EmbeddedICE.
  14 # So they must use "reset_config srst_pulls_trst".
  15
  16 # NOTE:  an expansion board could add a trace connector ... if
  17 # it does, change this appropriately.  And reset_config too,
  18 # assuming JTAG_DIS reroutes JTAG to that connector.
  19 etm config $_TARGETNAME 8 demultiplexed full dummy
  20 etm_dummy config $_TARGETNAME
  21
  22 # standard boards populate two 16 MB chips, but manufacturing
  23 # options or an expansion board could change this config.
  24 flash bank osk.u1 cfi 0x00000000 0x01000000 2 2 $_TARGETNAME
  25 flash bank osk.u2 cfi 0x01000000 0x01000000 2 2 $_TARGETNAME
  26
  27 proc osk5912_init {} {
  28         omap5912_reset
  29
  30         # detect flash
  31         flash probe 0
  32         flash probe 1
  33 }
  34 $_TARGETNAME configure -event reset-init { osk5912_init }
  35
  36 arm7_9 dcc_downloads enable