tcl/board/arm_musca_a.cfg

   1 # SPDX-License-Identifier: GPL-2.0-or-later
   2
   3 #
   4 # Configuration script for ARM Musca-A development board
   5 #
   6 # For now we do not support Musca A flash programming using OpenOCD. However, a
   7 # work area is configured for flash programming speed up.
   8 #
   9 # GDB considers all memory as RAM unless target supplies a memory map.
  10 # OpenOCD will only send memory map if flash banks are configured. Otherwise,
  11 # configure GDB after connection by issuing following commands:
  12 # (gdb) mem 0x10200000 0x109FFFFF ro
  13 # (gdb) mem 0x00200000 0x009FFFFF ro
  14 # (gdb) set mem inaccessible-by-default off
  15
  16 # ARM Musca A board supports both JTAG and SWD transports.
  17 source [find target/swj-dp.tcl]
  18
  19 # set a safe JTAG clock speed, can be overridden
  20 adapter speed 1000
  21
  22 global _CHIPNAME
  23 if { [info exists CHIPNAME] } {
  24         set _CHIPNAME $CHIPNAME
  25 } else {
  26         set _CHIPNAME MUSCA_A
  27 }
  28
  29 if { [info exists CPUTAPID] } {
  30         set _CPUTAPID $CPUTAPID
  31 } else {
  32         set _CPUTAPID 0x6ba00477
  33 }
  34
  35 # Enable CPU1 debugging as a separate GDB target
  36 set _ENABLE_CPU1 1
  37
  38 # Musca A1 has 32KB SRAM banks. Override default work-area-size to 8KB per CPU
  39 set WORKAREASIZE_CPU0 0x2000
  40 set WORKAREASIZE_CPU1 0x2000
  41
  42 # Set SRAM bank 1 to be used for work area. Override here if needed.
  43 set WORKAREAADDR_CPU0 0x30008000
  44 set WORKAREAADDR_CPU1 0x3000A000
  45
  46 source [find target/arm_corelink_sse200.cfg]