rename jtag_nsrst_assert_width as adapter_nsrst_assert_width

[openocd.git] / tcl / target / telo.cfg

diff --git a/tcl/target/telo.cfg b/tcl/target/telo.cfg
index 0cbdb816d9ec85a4fb1aabf43a4dbcb91fcbcc32..aa9ff2254728ba75b037586bb4e3f9523d9f187b 100644 (file)
--- a/tcl/target/telo.cfg
+++ b/tcl/target/telo.cfg
@@ -13,10 +13,10 @@ source [find target/c100helper.tcl]
 # use libftdi.so library instead with this script
 # make the reset asserted to
 # allow RC circuit to discharge for: [ms]
-jtag_nsrst_assert_width 100
+adapter_nsrst_assert_width 100
 jtag_ntrst_assert_width 100
 # don't talk to JTAG after reset for: [ms]
-jtag_nsrst_delay 100
+adapter_nsrst_delay 100
 jtag_ntrst_delay 100
 reset_config trst_and_srst separate
 
@@ -26,12 +26,12 @@ reset_config trst_and_srst separate
 # issue telnet: reset init
 # issue gdb: monitor reset init
 $_TARGETNAME configure -event reset-init {
-       jtag_khz 100
+       adapter_khz 100
        # this will setup Telo board
        setupTelo
        #turn up the JTAG speed
-       jtag_khz 3000
-       puts "JTAG speek now 3MHz"
+       adapter_khz 3000
+       puts "JTAG speed now 3MHz"
        puts "type helpC100 to get help on C100"
 }
 
@@ -58,4 +58,4 @@ set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME cfi 0x20000000 0x01000000 2 2 $_TARGETNAME
 
 # writing data to memory does not work without this
-memwrite burst disable
\ No newline at end of file
+memwrite burst disable