# script for str9
-if { [info exists CHIPNAME] } {
- set _CHIPNAME $CHIPNAME
-} else {
+if { [info exists CHIPNAME] } {
+ set _CHIPNAME $CHIPNAME
+} else {
set _CHIPNAME str912
}
-if { [info exists ENDIAN] } {
- set _ENDIAN $ENDIAN
-} else {
+if { [info exists ENDIAN] } {
+ set _ENDIAN $ENDIAN
+} else {
set _ENDIAN little
}
# jtag speed. We need to stick to 16kHz until we've finished reset.
jtag_rclk 16
-jtag_nsrst_delay 100
+adapter_nsrst_delay 100
jtag_ntrst_delay 100
#use combined on interfaces or targets that can't set TRST/SRST separately
$_TARGETNAME configure -event reset-init {
# We can increase speed now that we know the target is halted.
#jtag_rclk 3000
-
+
# -- Enable 96K RAM
# PFQBC enabled / DTCM & AHB wait-states disabled
- mww 0x5C002034 0x0191
+ mww 0x5C002034 0x0191
str9x flash_config 0 4 2 0 0x80000
flash protect 0 0 7 off
}
-$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x50000000 -work-area-size 16384 -work-area-backup 0
+$_TARGETNAME configure -work-area-phys 0x50000000 -work-area-size 16384 -work-area-backup 0
#flash bank str9x <base> <size> 0 0 <target#> <variant>
-flash bank str9x 0x00000000 0x00080000 0 0 0
-flash bank str9x 0x00080000 0x00008000 0 0 0
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME str9x 0x00000000 0x00080000 0 0 $_TARGETNAME
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME str9x 0x00080000 0x00008000 0 0 $_TARGETNAME
# For more information about the configuration files, take a look at:
# openocd.texi