tcl/target, board: remove useless gdb-attach event definitions

[openocd.git] / tcl / target / at91samdXX.cfg

diff --git a/tcl/target/at91samdXX.cfg b/tcl/target/at91samdXX.cfg
index 47b4f5f161cf5ef71c44cd1ab06d416f37de431f..f0644d1773a66e60ec72d1ee2a064134b8575220 100644 (file)
--- a/tcl/target/at91samdXX.cfg
+++ b/tcl/target/at91samdXX.cfg
@@ -34,9 +34,10 @@ if { [info exists CPUTAPID] } {
 }
 
 swj_newdap $_CHIPNAME cpu -irlen 4 -expected-id $_CPUTAPID
+dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu
 
 set _TARGETNAME $_CHIPNAME.cpu
-target create $_TARGETNAME cortex_m -endian $_ENDIAN -chain-position $_TARGETNAME
+target create $_TARGETNAME cortex_m -endian $_ENDIAN -dap $_CHIPNAME.dap
 
 $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
 
@@ -53,11 +54,6 @@ $_TARGETNAME configure -event reset-deassert-post {
 # srst_pulls_trst is not configured here to avoid an error raised in reset halt
 reset_config srst_gates_jtag
 
-# Atmel's EDBG (on-board cmsis-dap adapter of Xplained kits) cannot
-# stop the MCU before it starts executing code if hardware RESETN
-# line is configured by command "reset_config srst_only"
-# Use "reset_config none" (default) before flash programming.
-
 # Do not use a reset button with other SWD adapter than Atmel's EDBG.
 # DSU usually locks MCU in reset state until you issue a reset command
 # in OpenOCD.