cfg: add srst_nogate to the supported targets, remove from board configs

[openocd.git] / tcl / board / lubbock.cfg

diff --git a/tcl/board/lubbock.cfg b/tcl/board/lubbock.cfg
index 63cc2a41083e11fec68d2ac63dcf506dddf0bb05..298954cc0678f4a32d66f0e0fcb88c1a7c2e7689 100644 (file)
--- a/tcl/board/lubbock.cfg
+++ b/tcl/board/lubbock.cfg
@@ -4,7 +4,7 @@
 
 source [find target/pxa255.cfg]
 
-jtag_nsrst_delay 250
+adapter_nsrst_delay 250
 jtag_ntrst_delay 250
 
 # NOTE: until after pinmux and such are set up, only CS0 is
@@ -12,8 +12,10 @@ jtag_ntrst_delay 250
 
 # CS0, CS1 -- two banks of CFI flash, 32 MBytes each
 # each bank is 32-bits wide, two 16-bit chips in parallel
-flash bank cfi 0x00000000 0x02000000 2 4 $_TARGETNAME
-flash bank cfi 0x04000000 0x02000000 2 4 $_TARGETNAME
+set _FLASHNAME $_CHIPNAME.flash0
+flash bank $_FLASHNAME cfi 0x00000000 0x02000000 2 4 $_TARGETNAME
+set _FLASHNAME $_CHIPNAME.flash1
+flash bank $_FLASHNAME cfi 0x04000000 0x02000000 2 4 $_TARGETNAME
 
 # CS2 low -- FPGA registers
 # CS2 high -- 1 MByte SRAM at 0x0a00.0000 ... last 64K for scratch
@@ -36,7 +38,7 @@ proc hexled {u32} {
 
 proc lubbock_init {target} {
 
-       puts "Initialize PXA255 Lubbock board"
+       echo "Initialize PXA255 Lubbock board"
 
        # (1) pinmux