rename jtag_khz as adapter_khz

[openocd.git] / tcl / board / hitex_lpc2929.cfg

diff --git a/tcl/board/hitex_lpc2929.cfg b/tcl/board/hitex_lpc2929.cfg
index 7d06f7452116c2e7f717ba428e7c4afd68cb1e61..35cc7d0b90bc2abc323b2c306dbc6fe2213902ef 100644 (file)
--- a/tcl/board/hitex_lpc2929.cfg
+++ b/tcl/board/hitex_lpc2929.cfg
@@ -7,7 +7,7 @@ jtag_ntrst_delay 1
 
 # Maximum of 1/8 of clock frequency (XTAL = 16 MHz).
 # Adaptive clocking through RTCK is not supported.
-jtag_khz 2000
+adapter_khz 2000
 
 # Target device: LPC29xx with ETB
 # The following variables are used by the LPC2900 script:
@@ -24,7 +24,7 @@ $_TARGETNAME configure -work-area-phys 0x58000000 -work-area-size 0x10000 -work-
 # Event handlers
 $_TARGETNAME configure -event reset-start {
   # Back to the slow JTAG clock
-  jtag_khz 2000
+  adapter_khz 2000
 }
 
 # External 16-bit flash at chip select CS7 (SST39VF3201-70, 4 MiB)
@@ -46,7 +46,7 @@ $_TARGETNAME configure -event reset-init {
   mww 0xFFFF8070 0x02000000     # SYS_CLK_CONF: PLL
 
   # Increase JTAG speed
-  jtag_khz 6000
+  adapter_khz 6000
 
   # Enable external memory bus (16-bit SRAM at CS6, 16-bit flash at CS7)
   mww 0xE0001138 0x0000001F     # P1.14 = D0