rename jtag_khz as adapter_khz

[openocd.git] / tcl / board / at91sam9g20-ek.cfg

diff --git a/tcl/board/at91sam9g20-ek.cfg b/tcl/board/at91sam9g20-ek.cfg
index fb6068cc6369751044f568ed19a835c73c8c81d8..f24f1a13d895186f329233dbf376f8bf80f9d4aa 100644 (file)
--- a/tcl/board/at91sam9g20-ek.cfg
+++ b/tcl/board/at91sam9g20-ek.cfg
@@ -77,7 +77,7 @@ proc at91sam9g20_init { } {
        # means the master clock (MCLK) must be at or below 133 MHz or timing errors will occur.  The processor
        # core can operate up to 400 MHz and therefore PCLK must be at or below this to function properly.
 
-       jtag_khz 2                      # Slow-speed oscillator enabled at reset, so run jtag speed slow.
+       adapter_khz 2                   # Slow-speed oscillator enabled at reset, so run jtag speed slow.
        halt                            # Make sure processor is halted, or error will result in following steps.
        mww 0xfffffd08 0xa5000501       # RSTC_MR : enable user reset.
        mww 0xfffffd44 0x00008000       # WDT_MR : disable watchdog.
@@ -112,7 +112,7 @@ proc at91sam9g20_init { } {
 
        # Switch over to adaptive clocking.
 
-       jtag_khz 0
+       adapter_khz 0
 
        # Enable faster DCC downloads.