# #
#################################################################################################
+# FIXME use some standard target config, maybe create one from this
+#
+# source [find target/...cfg]
+
# Define basic characteristics for the CPU. The AT91SAM9G20 processor is a subtle variant of
# the AT91SAM9260 and shares the same tap ID as it.
jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
-# Use caution changing the delays listed below. These seem to be affected by the board and type of
-# debugger dongle. A value of 200 ms seems to work reliably for the configuration listed in the file header above.
+# Use caution changing the delays listed below. These seem to be
+# affected by the board and type of JTAG adapter. A value of 200 ms seems
+# to work reliably for the configuration listed in the file header above.
-jtag_nsrst_delay 200
+adapter_nsrst_delay 200
jtag_ntrst_delay 200
# Set fallback clock to 1/6 of worst-case clock speed (which would be the 32.768 kHz slow clock).
jtag_rclk 5
-set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
-target create $_TARGETNAME arm926ejs -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm926ejs
+set _TARGETNAME $_CHIPNAME.cpu
+target create $_TARGETNAME arm926ejs -endian $_ENDIAN -chain-position $_TARGETNAME
# Establish internal SRAM memory work areas that are important to pre-bootstrap loaders, etc. The
# AT91SAM9G20 has two SRAM areas, one starting at 0x00200000 and the other starting at 0x00300000.
# means the master clock (MCLK) must be at or below 133 MHz or timing errors will occur. The processor
# core can operate up to 400 MHz and therefore PCLK must be at or below this to function properly.
- jtag_khz 2 # Slow-speed oscillator enabled at reset, so run jtag speed slow.
+ adapter_khz 2 # Slow-speed oscillator enabled at reset, so run jtag speed slow.
halt # Make sure processor is halted, or error will result in following steps.
mww 0xfffffd08 0xa5000501 # RSTC_MR : enable user reset.
mww 0xfffffd44 0x00008000 # WDT_MR : disable watchdog.
# Switch over to adaptive clocking.
- jtag_khz 0
+ adapter_khz 0
# Enable faster DCC downloads.