retval = target_alloc_working_area(target, sizeof(spifi_init_code)
+ SPIFI_INIT_STACK_SIZE, &spifi_init_algorithm);
if (retval != ERROR_OK) {
- LOG_ERROR("Insufficient working area to initialize SPIFI "\
- "module. You must allocate at least %zdB of working "\
+ LOG_ERROR("Insufficient working area to initialize SPIFI "
+ "module. You must allocate at least %zdB of working "
"area in order to use this driver.",
sizeof(spifi_init_code) + SPIFI_INIT_STACK_SIZE
);
return retval;
}
- LOG_DEBUG("Writing algorithm to working area at 0x%08" TARGET_PRIxADDR,
+ LOG_DEBUG("Writing algorithm to working area at " TARGET_ADDR_FMT,
spifi_init_algorithm->address);
/* Write algorithm to working area */
retval = target_write_buffer(target,
* it, use a bulk erase instead of going sector-by-sector. */
if (first == 0 && last == (bank->num_sectors - 1)
&& lpcspifi_info->dev->chip_erase_cmd != lpcspifi_info->dev->erase_cmd) {
- LOG_DEBUG("Chip supports the bulk erase command."\
+ LOG_DEBUG("Chip supports the bulk erase command."
" Will use bulk erase instead of sector-by-sector erase.");
retval = lpcspifi_bulk_erase(bank);
retval = target_alloc_working_area(target, sizeof(lpcspifi_flash_erase_code),
&erase_algorithm);
if (retval != ERROR_OK) {
- LOG_ERROR("Insufficient working area. You must configure a working"\
+ LOG_ERROR("Insufficient working area. You must configure a working"
" area of at least %zdB in order to erase SPIFI flash.",
sizeof(lpcspifi_flash_erase_code));
return retval;
if (target_alloc_working_area(target, sizeof(lpcspifi_flash_write_code),
&write_algorithm) != ERROR_OK) {
- LOG_ERROR("Insufficient working area. You must configure"\
+ LOG_ERROR("Insufficient working area. You must configure"
" a working area > %zdB in order to write to SPIFI flash.",
sizeof(lpcspifi_flash_write_code));
return ERROR_TARGET_RESOURCE_NOT_AVAILABLE;
* space, free the algorithm */
target_free_working_area(target, write_algorithm);
- LOG_ERROR("Insufficient working area. Please allocate at least"\
+ LOG_ERROR("Insufficient working area. Please allocate at least"
" %zdB of working area to enable flash writes.",
sizeof(lpcspifi_flash_write_code) + 1
);
return ERROR_TARGET_RESOURCE_NOT_AVAILABLE;
} else if (fifo_size < page_size)
- LOG_WARNING("Working area size is limited; flash writes may be"\
- " slow. Increase working area size to at least %zdB"\
+ LOG_WARNING("Working area size is limited; flash writes may be"
+ " slow. Increase working area size to at least %zdB"
" to reduce write times.",
(size_t)(sizeof(lpcspifi_flash_write_code) + page_size)
);
return ERROR_OK;
}
-struct flash_driver lpcspifi_flash = {
+const struct flash_driver lpcspifi_flash = {
.name = "lpcspifi",
.flash_bank_command = lpcspifi_flash_bank_command,
.erase = lpcspifi_erase,