flash/nor/nrf5: detect newer devices without HWID table

[openocd.git] / doc / openocd.texi

diff --git a/doc/openocd.texi b/doc/openocd.texi
index bc77469c836520585cd4c6fa53435c8d8338dfea..af1684d00da6c023264d59bf57b112b9071f3915 100644 (file)
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -5138,7 +5138,7 @@ command or the flash driver then it defaults to 0xff.
 @end deffn
 
 @anchor{program}
-@deffn Command {program} filename [verify] [reset] [exit] [offset]
+@deffn Command {program} filename [preverify] [verify] [reset] [exit] [offset]
 This is a helper script that simplifies using OpenOCD as a standalone
 programmer. The only required parameter is @option{filename}, the others are optional.
 @xref{Flash Programming}.
@@ -6363,6 +6363,10 @@ works only for chips that do not have factory pre-programmed region 0
 code.
 @end deffn
 
+@deffn Command {nrf5 info}
+Decodes and shows informations from FICR and UICR registers.
+@end deffn
+
 @end deffn
 
 @deffn {Flash Driver} ocl
@@ -7528,6 +7532,7 @@ The script is executed as follows and by default the following actions will be p
 @item 'init' is executed.
 @item 'reset init' is called to reset and halt the target, any 'reset init' scripts are executed.
 @item @code{flash write_image} is called to erase and write any flash using the filename given.
+@item If the @option{preverify} parameter is given, the target is "verified" first and only flashed if this fails.
 @item @code{verify_image} is called if @option{verify} parameter is given.
 @item @code{reset run} is called if @option{reset} parameter is given.
 @item OpenOCD is shutdown if @option{exit} parameter is given.