mips: optimize write code for speed

[openocd.git] / doc / openocd.texi

diff --git a/doc/openocd.texi b/doc/openocd.texi
index 1604e9c6c2b712875ce2cca7b689b047b9c10982..c2ee20dea3e84517459f4575f4e148c2c35eff7b 100644 (file)
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -4075,7 +4075,7 @@ The value should normally correspond to a static mapping for the
 
 @item @code{-rtos} @var{rtos_type} -- enable rtos support for target,
 @var{rtos_type} can be one of @option{auto}|@option{eCos}|@option{ThreadX}|
-@option{FreeRTOS}|@option{linux}.
+@option{FreeRTOS}|@option{linux}|@option{ChibiOS}.
 
 @end itemize
 @end deffn
@@ -4652,6 +4652,30 @@ flash bank $_FLASHNAME cfi 0x00000000 0x02000000 2 4 $_TARGETNAME
 @c "cfi part_id" disabled
 @end deffn
 
+@deffn {Flash Driver} lpcspifi
+@cindex NXP SPI Flash Interface
+@cindex SPIFI
+@cindex lpcspifi
+NXP's LPC43xx and LPC18xx families include a proprietary SPI
+Flash Interface (SPIFI) peripheral that can drive and provide
+memory mapped access to external SPI flash devices.
+
+The lpcspifi driver initializes this interface and provides
+program and erase functionality for these serial flash devices.
+Use of this driver @b{requires} a working area of at least 1kB
+to be configured on the target device; more than this will
+significantly reduce flash programming times.
+
+The setup command only requires the @var{base} parameter. All
+other parameters are ignored, and the flash size and layout
+are configured by the driver.
+
+@example
+flash bank $_FLASHNAME lpcspifi 0x14000000 0 0 0 $_TARGETNAME
+@end example
+
+@end deffn
+
 @deffn {Flash Driver} stmsmi
 @cindex STMicroelectronics Serial Memory Interface
 @cindex SMI
@@ -7555,6 +7579,11 @@ A socket (TCP/IP) connection is typically started as follows:
 target remote localhost:3333
 @end example
 This would cause GDB to connect to the gdbserver on the local pc using port 3333.
+
+It is also possible to use the GDB extended remote protocol as follows:
+@example
+target extended-remote localhost:3333
+@end example
 @item
 A pipe connection is typically started as follows:
 @example