speed up, relocate function

[openocd.git] / doc / openocd.texi

diff --git a/doc/openocd.texi b/doc/openocd.texi
index 069367d91ade58d16271afc6d263331d6f828a5d..8b7e58887bf93b845e6e7311b0cfe313156a0ca3 100644 (file)
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -1677,7 +1677,7 @@ Again using the at91sam7 as an example, this can look like:
 $_TARGETNAME configure -work-area-phys 0x00200000 \
              -work-area-size 0x4000 -work-area-backup 0
 @end example
-@pxref{Define CPU targets working in SMP}
+
 @anchor{Define CPU targets working in SMP}
 @subsection Define CPU targets working in SMP
 @cindex SMP
@@ -3602,14 +3602,7 @@ At this writing, the supported CPU types and variants are:
 (Support for this is preliminary and incomplete.)
 @item @code{cortex_a8} -- this is an ARMv7 core with an MMU
 @item @code{cortex_m3} -- this is an ARMv7 core, supporting only the
-compact Thumb2 instruction set.  It supports one variant:
-@itemize @minus
-@item @code{lm3s} ... Use this when debugging older Stellaris LM3S targets.
-This will cause OpenOCD to use a software reset rather than asserting
-SRST, to avoid a issue with clearing the debug registers.
-This is fixed in Fury Rev B, DustDevil Rev B, Tempest; these revisions will
-be detected and the normal reset behaviour used.
-@end itemize
+compact Thumb2 instruction set.
 @item @code{dragonite} -- resembles arm966e
 @item @code{dsp563xx} -- implements Freescale's 24-bit DSP.
 (Support for this is still incomplete.)