From 9c5c3ab3d60285fb7976341031705d0340c5fe33 Mon Sep 17 00:00:00 2001 From: Icenowy Zheng Date: Tue, 10 Sep 2019 03:32:36 +0800 Subject: [PATCH] tcl/target: swm050: fix to allow to use with ST-Link Currently the code assumes the adapter uses raw SWD, and the expected ID code of the CPU is even wrong. An adapter speed is also not specified. All these prevents the config file to be used with ST-Link. Fix the config file, to allow it to be used with ST-Link. Change-Id: I1244320fabfe8ee23da5a56a592dbeddc72cc8d5 Signed-off-by: Icenowy Zheng Reviewed-on: http://openocd.zylin.com/5297 Tested-by: jenkins Reviewed-by: Caleb Szalacinski Reviewed-by: Tomas Vanek --- tcl/target/swm050.cfg | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) diff --git a/tcl/target/swm050.cfg b/tcl/target/swm050.cfg index a819f9c426..2c4ab34fea 100644 --- a/tcl/target/swm050.cfg +++ b/tcl/target/swm050.cfg @@ -1,5 +1,7 @@ # Synwit SWM050 +source [find target/swj-dp.tcl] + if { [info exists CHIPNAME] } { set _CHIPNAME $CHIPNAME } else { @@ -16,10 +18,10 @@ if { [info exists WORKAREASIZE] } { if { [info exists CPUTAPID] } { set _CPUTAPID $CPUTAPID } else { - set _CPUTAPID 0x410CC200 + set _CPUTAPID 0x0bb11477 } -swd newdap $_CHIPNAME cpu -expected-id $_CPUTAPID +swj_newdap $_CHIPNAME cpu -expected-id $_CPUTAPID dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu set _TARGETNAME $_CHIPNAME.cpu target create $_TARGETNAME cortex_m -dap $_CHIPNAME.dap @@ -27,6 +29,7 @@ $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE set _FLASHNAME $_CHIPNAME.flash flash bank $_FLASHNAME swm050 0x0 0x2000 0 0 $_TARGETNAME +adapter_khz 1000 $_TARGETNAME configure -event reset-init { # Stop the watchdog, just to be safe -- 2.30.2