Fw: [PATCH] OpenRD board configuration

Ofrwarded from Ron, who's not subscribed.

----- Forwarded message from Ron <ron@debian.org> -----

From: Ron <ron@debian.org>
Date: Wed, 14 Oct 2009 04:50:17 +1030
To: wookey@debian.org
Subject: [PATCH] OpenRD board configuration
X-Spam-Status: No, score=-3.6 required=4.5 tests=BAYES_00,RCVD_IN_DNSWL_LOW
	autolearn=ham version=3.2.5

This piggybacks on the 'sheevaplug' layout which uses the same Kirkwood SoC.

Signed-off-by: Ron Lee <ron@debian.org>

diff --git a/tcl/board/openrd.cfg b/tcl/board/openrd.cfg
new file mode 100644 (file)
index 0000000..a77dcdb
--- /dev/null
+++ b/tcl/board/openrd.cfg
@@ -0,0 +1,122 @@
+# Marvell OpenRD
+
+source [find interface/openrd.cfg]
+source [find target/feroceon.cfg]
+
+$_TARGETNAME configure \
+       -work-area-phys 0x10000000 \
+       -work-area-size 65536 \
+       -work-area-backup 0
+
+arm7_9 dcc_downloads enable
+
+# this assumes the hardware default peripherals location before u-Boot moves it
+nand device orion 0 0xd8000000
+
+proc openrd_init { } {
+
+       # We need to assert DBGRQ while holding nSRST down.
+       # However DBGACK will be set only when nSRST is released.
+       # Furthermore, the JTAG interface doesn't respond at all when
+       # the CPU is in the WFI (wait for interrupts) state, so it is
+       # possible that initial tap examination failed.  So let's
+       # re-examine the target again here when nSRST is asserted which
+       # should then succeed.
+       jtag_reset 0 1
+       feroceon.cpu arp_examine
+       halt 0
+       jtag_reset 0 0
+       wait_halt
+
+       arm926ejs cp15 0 0 1 0 0x00052078
+
+       mww 0xD0001400 0x43000C30 #  DDR SDRAM Configuration Register
+       mww 0xD0001404 0x37543000 #  Dunit Control Low Register
+       mww 0xD0001408 0x22125451 #  DDR SDRAM Timing (Low) Register
+       mww 0xD000140C 0x00000A33 #  DDR SDRAM Timing (High) Register
+       mww 0xD0001410 0x000000CC #  DDR SDRAM Address Control Register
+       mww 0xD0001414 0x00000000 #  DDR SDRAM Open Pages Control Register
+       mww 0xD0001418 0x00000000 #  DDR SDRAM Operation Register
+       mww 0xD000141C 0x00000C52 #  DDR SDRAM Mode Register
+       mww 0xD0001420 0x00000004 #  DDR SDRAM Extended Mode Register
+       mww 0xD0001424 0x0000F17F #  Dunit Control High Register
+       mww 0xD0001428 0x00085520 #  Dunit Control High Register
+       mww 0xD000147c 0x00008552 #  Dunit Control High Register
+       mww 0xD0001504 0x0FFFFFF1 #  CS0n Size Register
+       mww 0xD0001508 0x10000000 #  CS1n Base Register
+       mww 0xD000150C 0x0FFFFFF5 #  CS1n Size Register
+       mww 0xD0001514 0x00000000 #  CS2n Size Register
+       mww 0xD000151C 0x00000000 #  CS3n Size Register
+       mww 0xD0001494 0x00120012 #  DDR2 SDRAM ODT Control (Low) Register
+       mww 0xD0001498 0x00000000 #  DDR2 SDRAM ODT Control (High) REgister
+       mww 0xD000149C 0x0000E40F #  DDR2 Dunit ODT Control Register
+       mww 0xD0001480 0x00000001 #  DDR SDRAM Initialization Control Register
+       mww 0xD0020204 0x00000000 #  Main IRQ Interrupt Mask Register
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+       mww 0xD0020204 0x00000000 #              "
+
+       mww 0xD0010000 0x01111111 #  MPP  0 to 7
+       mww 0xD0010004 0x11113322 #  MPP  8 to 15
+       mww 0xD0010008 0x00001111 #  MPP 16 to 23
+
+       mww 0xD0010418 0x003E07CF #  NAND Read Parameters REgister
+       mww 0xD001041C 0x000F0F0F #  NAND Write Parameters Register
+       mww 0xD0010470 0x01C7D943 #  NAND Flash Control Register
+
+}
+
+proc openrd_reflash_uboot { } {
+
+       # reflash the u-Boot binary and reboot into it
+       openrd_init
+       nand probe 0
+       nand erase 0 0x0 0xa0000
+       nand write 0 uboot.bin 0 oob_softecc_kw
+       resume
+
+}
+
+proc openrd_load_uboot { } {
+
+       # load u-Boot into RAM and execute it
+       openrd_init
+       load_image uboot.elf
+       verify_image uboot.elf
+       resume 0x00600000
+
+}
+

diff --git a/tcl/interface/openrd.cfg b/tcl/interface/openrd.cfg
new file mode 100644 (file)
index 0000000..b01205b
--- /dev/null
+++ b/tcl/interface/openrd.cfg
@@ -0,0 +1,12 @@
+#
+# Marvell OpenRD
+#
+# http://www.marvell.com/products/embedded_processors/developer/kirkwood/openrd.jsp
+#
+
+interface ft2232
+ft2232_layout sheevaplug
+ft2232_vid_pid 0x0403 0x9e90
+ft2232_device_desc "OpenRD JTAGKey FT2232D B"
+jtag_khz 3000
+