tcl/board: update ST NUCLEO-H745ZI-Q configuration file to use dapdirect

this board embeds and STLINK DAP capable firmware

Change-Id: I276e9f44ad6cf7d1ff664898bbc884676bdbc967
Signed-off-by: Tarek BOCHKATI <tarek.bouchkati@gmail.com>
Reviewed-on: http://openocd.zylin.com/5316
Reviewed-by: Tomas Vanek <vanekt@fbl.cz>
Tested-by: jenkins
Reviewed-by: Antonio Borneo <borneo.antonio@gmail.com>

diff --git a/tcl/board/st_nucleo_h745zi.cfg b/tcl/board/st_nucleo_h745zi.cfg
index bb8a396b54db6ae572bcb7c1e63b4fd9393ae726..22d36f686c9e7e3d3bcdaeaa2f96c84cc7b077e7 100644 (file)
--- a/tcl/board/st_nucleo_h745zi.cfg
+++ b/tcl/board/st_nucleo_h745zi.cfg
@@ -1,16 +1,14 @@
 # This is an ST NUCLEO-H745ZI-Q board with single STM32H745ZITx chip.
 
-source [find interface/stlink.cfg]
-transport select hla_swd
+source [find interface/stlink-dap.cfg]
+transport select dapdirect_swd
 
-# ST-Link HLA interface do not support multi-AP debugging
-# then setting DUAL_CORE and USE_CTI has no effect, because
-# it will fall back to single core configuration
+# STM32H745xx devices are dual core (Cortex-M7 and Cortex-M4)
 set DUAL_CORE 1
+
+# enable CTI for cross halting both cores
 set USE_CTI 1
 
 source [find target/stm32h7x_dual_bank.cfg]
 
-# when using ST-Link HLA adapter, DBGMCU accesses are done via AP0
-# unfortunately DBGMCU is not accessible when SRST is asserted
 reset_config srst_only