X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=tcl%2Ftarget%2Fstr730.cfg;h=a1491ff158c2c738da3f3646cbfe050c3e192e55;hp=6432d1542841e05584a8b3f40edcad6b9f950d5e;hb=3f9d377ce788365844f9225064cb9b0f0b4542ef;hpb=2dfa5e9c844a5a3f8aaca146c874f13570b8f667

diff --git a/tcl/target/str730.cfg b/tcl/target/str730.cfg
index 6432d15428..a1491ff158 100644
--- a/tcl/target/str730.cfg
+++ b/tcl/target/str730.cfg
@@ -1,6 +1,6 @@
 #STR730 CPU
 
-jtag_khz 3000
+adapter_khz 3000
 
 if { [info exists CHIPNAME] } {
    set  _CHIPNAME $CHIPNAME
@@ -27,21 +27,28 @@ reset_config trst_and_srst srst_pulls_trst
 jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0x0f -expected-id $_CPUTAPID
 
 #jtag nTRST and nSRST delay
-jtag_nsrst_delay 500
+adapter_nsrst_delay 500
 jtag_ntrst_delay 500
 
 set _TARGETNAME $_CHIPNAME.cpu
 target create $_TARGETNAME arm7tdmi -endian little -chain-position 0 -variant arm7tdmi
 
-$_TARGETNAME configure -event reset-start { jtag_khz 10 }
-$_TARGETNAME configure -event reset-init { jtag_khz 3000 }
+$_TARGETNAME configure -event reset-start { adapter_khz 10 }
+$_TARGETNAME configure -event reset-init {
+	adapter_khz 3000
+
+# Because the hardware cannot be interrogated for the protection state
+# of sectors, initialize all the sectors to be unprotected. The initial
+# state is reflected by the driver, too.
+	flash protect 0 0 last off
+}
 $_TARGETNAME configure -event gdb-flash-erase-start {
 	flash protect 0 0 7 off
 }
 
-$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
+$_TARGETNAME configure -work-area-phys 0xA0000000 -work-area-size 0x4000 -work-area-backup 0
 
 #flash bank <driver> <base> <size> <chip_width> <bus_width>
 set _FLASHNAME $_CHIPNAME.flash
-flash bank $_FLASHNAME str7x 0x20000000 0x00040000 0 0 0 STR3x
+flash bank $_FLASHNAME str7x 0x80000000 0x00040000 0 0 $_TARGETNAME STR3x