X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=tcl%2Ftarget%2Flpc2478.cfg;h=b0af4c02d77ad591f34364706c0c5527767d347d;hp=1d2058b0440afdcd12e51a05093fbcb7f32b50e6;hb=f86137066a6b42c46c457c9837a8015990bf71e6;hpb=2e29131f2b858c57430c703f73736364b51cb729
diff --git a/tcl/target/lpc2478.cfg b/tcl/target/lpc2478.cfg
index 1d2058b044..b0af4c02d7 100644
--- a/tcl/target/lpc2478.cfg
+++ b/tcl/target/lpc2478.cfg
@@ -31,11 +31,11 @@ set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
# LPC2478 has 64kB of SRAM on its main system bus (so-called Local On-Chip SRAM)
-$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x10000 -work-area-backup 0
+$_TARGETNAME configure -work-area-phys 0x40000000 -work-area-size 0x10000 -work-area-backup 0
$_TARGETNAME configure -event reset-init {
# Force target into ARM state
- armv4_5 core_state arm
+ arm core_state arm
# Do not remap 0x0000-0x0020 to anything but the Flash
mwb 0xE01FC040 0x01
}
@@ -43,7 +43,7 @@ $_TARGETNAME configure -event reset-init {
# LPC2378 has 512kB of FLASH, but upper 8kB are occupied by bootloader.
# After reset the chip uses its internal 4MHz RC oscillator.
# flash bank lpc2000 0 0 [calc checksum]
-flash bank lpc2000 0x0 0x7D000 0 0 0 lpc2000_v2 12000 calc_checksum
+flash bank lpc2000 0x0 0x7D000 0 0 $_TARGETNAME lpc2000_v2 12000 calc_checksum
# Try to use RCLK, if RCLK is not available use "normal" mode. 4MHz / 6 = 666kHz, so use 500.
jtag_rclk 500