X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=src%2Fflash%2Fnand%2Fat91sam9.c;h=92ab047f623a3e9972c3dcc79066d3b48c14805a;hp=5cfbb0a38611b9fc20ead51711c3e384f61ad0d8;hb=2a76c1bcf94f8ed00c9e744a5405d0ac07cdc85a;hpb=ae710059291ba9830a9b20d899bdef6a5122dd73

diff --git a/src/flash/nand/at91sam9.c b/src/flash/nand/at91sam9.c
index 5cfbb0a386..92ab047f62 100644
--- a/src/flash/nand/at91sam9.c
+++ b/src/flash/nand/at91sam9.c
@@ -697,28 +697,30 @@ static const struct command_registration at91sam9_sub_command_handlers[] = {
 		.handler = handle_at91sam9_cle_command,
 		.mode = COMMAND_CONFIG,
 		.help = "set command latch enable address line (default is 22)",
-		.usage = "<device_id> <address_line>",
+		.usage = "bank_id address_line",
 	},
 	{
 		.name = "ale",
 		.handler = handle_at91sam9_ale_command,
 		.mode = COMMAND_CONFIG,
 		.help = "set address latch enable address line (default is 21)",
-		.usage = "<device_id> <address_line>",
+		.usage = "bank_id address_line",
 	},
 	{
 		.name = "rdy_busy",
 		.handler = handle_at91sam9_rdy_busy_command,
 		.mode = COMMAND_CONFIG,
-		.help = "set the input pin connected to RDY/~BUSY signal (no default)",
-		.usage = "<device_id> <base_pioc> <pin_num>",
+		.help = "set the GPIO input pin connected to "
+			"the RDY/~BUSY signal (no default)",
+		.usage = "bank_id pio_base_addr pin_num",
 	},
 	{
 		.name = "ce",
 		.handler = handle_at91sam9_ce_command,
 		.mode = COMMAND_CONFIG,
-		.help = "set the output pin connected to chip enable signal (no default)",
-		.usage = "<device_id> <base_pioc> <pin_num>",
+		.help = "set the GPIO output pin connected to "
+			"the chip enable signal (no default)",
+		.usage = "bank_id pio_base_addr pin_num",
 	},
 	COMMAND_REGISTRATION_DONE
 };