X-Git-Url: https://review.openocd.org/gitweb?p=openocd.git;a=blobdiff_plain;f=NEWS;h=db4485dae172db70034a605b551ca33b28e42594;hp=924ee372abf669b77319a5d24dfe2f2c21e61920;hb=3f9d377ce788365844f9225064cb9b0f0b4542ef;hpb=b559b273b526b3077b3ca219eecc8df9f86efac0

diff --git a/NEWS b/NEWS
index 924ee372ab..db4485dae1 100644
--- a/NEWS
+++ b/NEWS
@@ -6,15 +6,26 @@ and other issues not mentioned here.
 JTAG Layer:
 	New driver for "Bus Pirate"
 	Rename various commands so they're not JTAG-specific
-	   There are migration procedures for these, but you should
+	   There are migration procedures for most of these, but you should
 	   convert your scripts to the new names, since those procedures
 	   will not be around forever.
+		jtag jinterface ... is now adapter_name
 	   	jtag_khz	... is now adapter_khz
 		jtag_nsrst_delay ... is now adapter_nsrst_delay
+		jtag_nsrst_assert_width ... is now adapter_nsrst_assert_width
+	Support Voipac VPACLink JTAG Adapter.
 
 Boundary Scan:
 
 Target Layer:
+	ARM:
+		- basic semihosting support (ARMv7M).
+		- renamed "armv7m" command prefix as "arm"
+	MIPS:
+		- "ejtag_srst" variant removed. The same functionality is
+		  obtained by using "reset_config none".
+		- added PIC32MX software reset support, this means srst is not
+		  required to be connected anymore.
 
 Flash Layer:
 	New "stellaris recover" command, implements the procedure
@@ -22,12 +33,23 @@ Flash Layer:
 		state to the factory defaults, including erasing
 		the flash and its protection bits, and possibly
 		re-enabling hardware debugging).
-
+	PIC32MX now uses algorithm for flash programming, this
+		has increased the performance by approx 96%.
+	New 'pic32mx unlock' cmd to remove readout protection.
+	New STM32 Value Line Support.
+	New 'virtual' flash driver, used to associate other addresses
+		with a flash bank. See pic32mx.cfg for usage.
+	New iMX27 NAND flash controller driver.
 
 Board, Target, and Interface Configuration Scripts:
 	Support IAR LPC1768 kickstart board (by Olimex)
+	Support Voipac PXA270/PXA270M module.
+	New $PARPORTADDR tcl variable used to change default
+		parallel port address used.
 
 Core Jim/TCL Scripting:
+	New "add_script_search_dir" command, behaviour is the same
+		as the "-s" cmd line option.
 
 Documentation: