swd: Remove DAP from parameter list

[openocd.git] / src / jtag / swd.h

diff --git a/src/jtag/swd.h b/src/jtag/swd.h
index 41baec175d560d4299f4f3ba5ac02ff142e49615..d208f393b15d3071a12581dedd9a9e408d3b1445 100644 (file)
--- a/src/jtag/swd.h
+++ b/src/jtag/swd.h
@@ -153,48 +153,47 @@ struct swd_driver {
         * queued transactions are executed. If the frequency is lowered, it may
         * apply immediately.
         *
-        * @param dap The DAP controlled by the SWD link.
         * @param hz The desired frequency in Hz.
         * @return The actual resulting frequency after rounding.
         */
-       int_least32_t (*frequency)(struct adiv5_dap *dap, int_least32_t hz);
+       int_least32_t (*frequency)(int_least32_t hz);
 
        /**
         * Queue a special SWDIO sequence.
         *
-        * @param dap The DAP controlled by the SWD link.
         * @param seq The special sequence to generate.
         * @return ERROR_OK if the sequence was queued, negative error if the
         * sequence is unsupported.
         */
-       int (*switch_seq)(struct adiv5_dap *dap, enum swd_special_seq seq);
+       int (*switch_seq)(enum swd_special_seq seq);
 
        /**
         * Queued read of an AP or DP register.
         *
-        * @param dap The DAP controlled by the SWD link.
         * @param Command byte with APnDP/RnW/addr/parity bits
         * @param Where to store value to read from register
+        * @param ap_delay_hint Number of idle cycles that may be
+        * needed after an AP access to avoid WAITs
         */
-       void (*read_reg)(struct adiv5_dap *dap, uint8_t cmd, uint32_t *value);
+       void (*read_reg)(uint8_t cmd, uint32_t *value, uint32_t ap_delay_hint);
 
        /**
         * Queued write of an AP or DP register.
         *
-        * @param dap The DAP controlled by the SWD link.
         * @param Command byte with APnDP/RnW/addr/parity bits
         * @param Value to be written to the register
+        * @param ap_delay_hint Number of idle cycles that may be
+        * needed after an AP access to avoid WAITs
         */
-       void (*write_reg)(struct adiv5_dap *dap, uint8_t cmd, uint32_t value);
+       void (*write_reg)(uint8_t cmd, uint32_t value, uint32_t ap_delay_hint);
 
        /**
         * Execute any queued transactions and collect the result.
         *
-        * @param dap The DAP controlled by the SWD link.
         * @return ERROR_OK on success, Ack response code on WAIT/FAULT
         * or negative error code on other kinds of failure.
         */
-       int (*run)(struct adiv5_dap *dap);
+       int (*run)(void);
 
        /**
         * Configures data collection from the Single-wire
@@ -208,7 +207,7 @@ struct swd_driver {
         *
         * @return ERROR_OK on success, else a negative fault code.
         */
-       int *(*trace)(struct adiv5_dap *dap, bool swo);
+       int *(*trace)(bool swo);
 };
 
 int swd_init_reset(struct command_context *cmd_ctx);