# Testing feeedback wanted!
set _CHIPNAME lpc2478
set _ENDIAN little
set _CPUTAPID 0x4f1f0f0f

# Use RCLK. If RCLK is not available fall back to 500kHz. 
# 
# Depending on cabling you might be able to eek this up to 2000kHz.
jtag_rclk 500

jtag_nsrst_delay 200
jtag_ntrst_delay 200

#use combined on interfaces or targets that can't set TRST/SRST separately
reset_config trst_and_srst srst_pulls_trst


jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID

set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0


$_TARGETNAME configure -event reset-init {
	# Force target into ARM state
	soft_reset_halt
	# FIX!!!! should we remap the range below??? Is this applicable to
	# Copied from LPC2148.
	#do not remap 0x0000-0x0020 to anything but the flash
	mwb 0xE01FC040 0x01
}


flash bank lpc2000 0x0 0x7D000 0 0 0 lpc2000_v2 12000 calc_checksum