# str910-eval eval board # # Need reset scripts reset_config trst_and_srst # FIXME use some standard target config, maybe create one from this # # source [find target/...cfg] if { [info exists CHIPNAME] } { set _CHIPNAME $CHIPNAME } else { set _CHIPNAME str912 } if { [info exists ENDIAN] } { set _ENDIAN $ENDIAN } else { set _ENDIAN little } if { [info exists FLASHTAPID] } { set _FLASHTAPID $FLASHTAPID } else { set _FLASHTAPID 0x04570041 } jtag newtap $_CHIPNAME flash -irlen 8 -ircapture 0x1 -irmask 0x1 -expected-id $_FLASHTAPID if { [info exists CPUTAPID] } { set _CPUTAPID $CPUTAPID } else { set _CPUTAPID 0x25966041 } jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID if { [info exists BSTAPID] } { set _BSTAPID $BSTAPID } else { set _BSTAPID 0x1457f041 } jtag newtap $_CHIPNAME bs -irlen 5 -ircapture 0x1 -irmask 0x1 -expected-id $_BSTAPID set _TARGETNAME $_CHIPNAME.cpu target create $_TARGETNAME arm966e -endian $_ENDIAN -chain-position $_TARGETNAME $_TARGETNAME configure -work-area-phys 0x50000000 -work-area-size 16384 -work-area-backup 1 $_TARGETNAME configure -event reset-init { # We can increase speed now that we know the target is halted. #jtag_rclk 3000 # -- Enable 96K RAM # PFQBC enabled / DTCM & AHB wait-states disabled mww 0x5C002034 0x0191 str9x flash_config 0 4 2 0 0x80000 flash protect 0 0 7 off } #flash bank str9x 0 0 set _FLASHNAME $_CHIPNAME.flash0 flash bank $_FLASHNAME str9x 0x00000000 0x00080000 0 0 0 set _FLASHNAME $_CHIPNAME.flash1 flash bank $_FLASHNAME str9x 0x00080000 0x00008000 0 0 0