# This is an ST NUCLEO-H745ZI-Q board with single STM32H745ZITx chip.

source [find interface/stlink.cfg]
transport select hla_swd

# ST-Link HLA interface do not support multi-AP debugging
# then setting DUAL_CORE and USE_CTI has no effect, because
# it will fall back to single core configuration
set DUAL_CORE 1
set USE_CTI 1

source [find target/stm32h7x_dual_bank.cfg]

# when using ST-Link HLA adapter, DBGMCU accesses are done via AP0
# unfortunately DBGMCU is not accessible when SRST is asserted
reset_config srst_only