tcl/target/str710.cfg

   1 #start slow, speed up after reset
   2 adapter_khz 10
   3
   4 if { [info exists CHIPNAME] } {
   5    set _CHIPNAME $CHIPNAME
   6 } else {
   7    set _CHIPNAME str710
   8 }
   9
  10 if { [info exists ENDIAN] } {
  11    set _ENDIAN $ENDIAN
  12 } else {
  13    set _ENDIAN little
  14 }
  15
  16 if { [info exists CPUTAPID] } {
  17    set _CPUTAPID $CPUTAPID
  18 } else {
  19    set _CPUTAPID 0x3f0f0f0f
  20 }
  21
  22 #use combined on interfaces or targets that can't set TRST/SRST separately
  23 reset_config trst_and_srst srst_pulls_trst
  24
  25 #jtag scan chain
  26
  27 jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0x0f -expected-id $_CPUTAPID
  28
  29 set _TARGETNAME $_CHIPNAME.cpu
  30 target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME
  31
  32 $_TARGETNAME configure -event reset-start { adapter_khz 10 }
  33 $_TARGETNAME configure -event reset-init {
  34         adapter_khz 6000
  35
  36 # Because the hardware cannot be interrogated for the protection state
  37 # of sectors, initialize all the sectors to be unprotected. The initial
  38 # state is reflected by the driver, too.
  39         flash protect 0 0 last off
  40         flash protect 1 0 last off
  41 }
  42 $_TARGETNAME configure -event gdb-flash-erase-start {
  43         flash protect 0 0 7 off
  44         flash protect 1 0 1 off
  45 }
  46
  47 $_TARGETNAME configure -work-area-phys 0x2000C000 -work-area-size 0x4000 -work-area-backup 0
  48
  49 #flash bank str7x <base> <size> 0 0 <target#> <variant>
  50 set _FLASHNAME $_CHIPNAME.flash0
  51 flash bank $_FLASHNAME str7x 0x40000000 0x00040000 0 0 $_TARGETNAME STR71x
  52 set _FLASHNAME $_CHIPNAME.flash1
  53 flash bank $_FLASHNAME str7x 0x400C0000 0x00004000 0 0 $_TARGETNAME STR71x