tcl/target/stm8s.cfg

   1 # script for stm8s family
   2
   3 #
   4 # stm8 devices support SWIM transports only.
   5 #
   6
   7 transport select stlink_swim
   8
   9 if { [info exists CHIPNAME] } {
  10    set _CHIPNAME $CHIPNAME
  11 } else {
  12    set _CHIPNAME stm8s
  13 }
  14
  15 # Work-area is a space in RAM used for flash programming
  16 # By default use 1kB
  17 if { [info exists WORKAREASIZE] } {
  18    set _WORKAREASIZE $WORKAREASIZE
  19 } else {
  20    set _WORKAREASIZE 0x400
  21 }
  22
  23 if { [info exists FLASHSTART] } {
  24    set _FLASHSTART $FLASHSTART
  25 } else {
  26    set _FLASHSTART 0x8000
  27 }
  28
  29 if { [info exists FLASHEND] } {
  30    set _FLASHEND $FLASHEND
  31 } else {
  32    set _FLASHEND 0xffff
  33 }
  34
  35 if { [info exists EEPROMSTART] } {
  36    set _EEPROMSTART $EEPROMSTART
  37 } else {
  38    set _EEPROMSTART 0x4000
  39 }
  40
  41 if { [info exists EEPROMEND] } {
  42    set _EEPROMEND $EEPROMEND
  43 } else {
  44    set _EEPROMEND 0x43ff
  45 }
  46
  47 if { [info exists OPTIONSTART] } {
  48    set _OPTIONSTART $OPTIONSTART
  49 } else {
  50    set _OPTIONSTART 0x4800
  51 }
  52
  53 if { [info exists OPTIONEND] } {
  54    set _OPTIONEND $OPTIONEND
  55 } else {
  56    set _OPTIONEND 0x487f
  57 }
  58
  59 if { [info exists BLOCKSIZE] } {
  60    set _BLOCKSIZE $BLOCKSIZE
  61 } else {
  62    set _BLOCKSIZE 0x80
  63 }
  64
  65 hla newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id 0
  66
  67 set _TARGETNAME $_CHIPNAME.cpu
  68
  69 target create $_TARGETNAME stm8 -chain-position $_CHIPNAME.cpu
  70
  71 $_TARGETNAME configure -work-area-phys 0x0 -work-area-size $_WORKAREASIZE -work-area-backup 1
  72 $_TARGETNAME configure -flashstart $_FLASHSTART -flashend $_FLASHEND -eepromstart $_EEPROMSTART -eepromend $_EEPROMEND
  73 $_TARGETNAME configure -optionstart $_OPTIONSTART -optionend $_OPTIONEND -blocksize $_BLOCKSIZE
  74
  75 # Uncomment this line to enable interrupts while instruction step
  76 #$_TARGETNAME configure -enable_step_irq
  77
  78 # Set low speed at debug entry
  79 adapter speed 363
  80
  81 reset_config srst_only
  82
  83 # uncomment this line to connect under reset
  84 #reset_config srst_nogate connect_assert_srst