tcl/target/lpc2478.cfg

   1 # Testing feeedback wanted!
   2 set _CHIPNAME lpc2478
   3 set _ENDIAN little
   4 set _CPUTAPID 0x4f1f0f0f
   5
   6 # Use RCLK. If RCLK is not available fall back to 500kHz.
   7 #
   8 # Depending on cabling you might be able to eek this up to 2000kHz.
   9 jtag_rclk 500
  10
  11 jtag_nsrst_delay 200
  12 jtag_ntrst_delay 200
  13
  14 #use combined on interfaces or targets that can't set TRST/SRST separately
  15 reset_config trst_and_srst srst_pulls_trst
  16
  17
  18 jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
  19
  20 set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
  21 target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4
  22 $_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x4000 -work-area-backup 0
  23
  24
  25 $_TARGETNAME configure -event reset-init {
  26         # Force target into ARM state
  27         soft_reset_halt
  28         # FIX!!!! should we remap the range below??? Is this applicable to
  29         # Copied from LPC2148.
  30         #do not remap 0x0000-0x0020 to anything but the flash
  31         mwb 0xE01FC040 0x01
  32 }
  33
  34
  35 flash bank lpc2000 0x0 0x7D000 0 0 0 lpc2000_v2 12000 calc_checksum