jtag: linuxgpiod: drop extra parenthesis

[openocd.git] / tcl / target / bcm2836.cfg

# SPDX-License-Identifier: GPL-2.0-or-later

# The Broadcom chip used in the Raspberry Pi 2 Model B

# Partial information is available in raspberry pi website:
# https://www.raspberrypi.org/documentation/hardware/raspberrypi/bcm2836

if { [info exists CHIPNAME] } {
        set  _CHIPNAME $CHIPNAME
} else {
        set  _CHIPNAME bcm2836
}

if { [info exists CHIPCORES] } {
        set _cores $CHIPCORES
} else {
        set _cores 4
}

if { [info exists USE_SMP] } {
        set _USE_SMP $USE_SMP
} else {
        set _USE_SMP 0
}

if { [info exists DAP_TAPID] } {
        set _DAP_TAPID $DAP_TAPID
} else {
        set _DAP_TAPID 0x4ba00477
}

jtag newtap $_CHIPNAME cpu -expected-id $_DAP_TAPID -irlen 4
adapter speed 4000

dap create $_CHIPNAME.dap -chain-position $_CHIPNAME.cpu

# MEM-AP for direct access
target create $_CHIPNAME.ap mem_ap -dap $_CHIPNAME.dap -ap-num 0

# these addresses are obtained from the ROM table via 'dap info 0' command
set _DBGBASE {0x80010000 0x80012000 0x80014000 0x80016000}

set _smp_command "target smp"

for { set _core 0 } { $_core < $_cores } { incr _core } {
        set _TARGETNAME $_CHIPNAME.cpu$_core

        target create $_TARGETNAME cortex_a -dap $_CHIPNAME.dap -coreid $_core -dbgbase [lindex $_DBGBASE $_core]
        $_TARGETNAME configure -event reset-assert-post { cortex_a dbginit }

        set _smp_command "$_smp_command $_CHIPNAME.cpu$_core"
}

if {$_USE_SMP} {
        eval $_smp_command
}

# default target is cpu0
targets $_CHIPNAME.cpu0