tcl/target/at91sam7se512.cfg

   1 # ATMEL sam7se512
   2 # Example: the "Elektor Internet Radio" - EIR
   3 # http://www.ethernut.de/en/hardware/eir/index.html
   4
   5 if { [info exists CHIPNAME] } {
   6    set _CHIPNAME $CHIPNAME
   7 } else {
   8    set _CHIPNAME sam7se512
   9 }
  10
  11 if { [info exists ENDIAN] } {
  12    set _ENDIAN $ENDIAN
  13 } else {
  14    set _ENDIAN little
  15 }
  16
  17 if { [info exists CPUTAPID] } {
  18    set _CPUTAPID $CPUTAPID
  19 } else {
  20    # Force an error until we get a good number.
  21    set _CPUTAPID 0xffffffff
  22 }
  23
  24 #use combined on interfaces or targets that can't set TRST/SRST separately
  25 reset_config srst_only srst_pulls_trst
  26
  27 #jtag scan chain
  28 jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
  29
  30 # The target
  31 set _TARGETNAME $_CHIPNAME.cpu
  32 target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME
  33
  34 $_TARGETNAME configure -work-area-phys 0x00200000 -work-area-size 0x4000 -work-area-backup 0
  35
  36 #flash bank <driver> <base_addr> <size> <chip_width> <bus_width> <target_number> [<target_name> <banks> <sectors_per_bank> <pages_per_sector> <page_size> <num_nvmbits> <ext_freq_khz>]
  37 set _FLASHNAME $_CHIPNAME.flash
  38 flash bank $_FLASHNAME at91sam7 0 0 0 0 $_TARGETNAME 0 0 0 0 0 0 0 18432
  39