tcl/board/arm_musca_a.cfg

   1 #
   2 # Configuration script for ARM Musca-A development board
   3 #
   4 # For now we do not support Musca A flash programming using OpenOCD. However, a
   5 # work area is configured for flash programming speed up.
   6 #
   7 # GDB considers all memory as RAM unless target supplies a memory map.
   8 # OpenOCD will only send memory map if flash banks are configured. Otherwise,
   9 # configure GDB after connection by issuing following commands:
  10 # (gdb) mem 0x10200000 0x109FFFFF ro
  11 # (gdb) mem 0x00200000 0x009FFFFF ro
  12 # (gdb) set mem inaccessible-by-default off
  13
  14 # ARM Musca A board supports both JTAG and SWD transports.
  15 source [find target/swj-dp.tcl]
  16
  17 # set a safe JTAG clock speed, can be overridden
  18 adapter speed 1000
  19
  20 global _CHIPNAME
  21 if { [info exists CHIPNAME] } {
  22         set _CHIPNAME $CHIPNAME
  23 } else {
  24         set _CHIPNAME MUSCA_A
  25 }
  26
  27 if { [info exists CPUTAPID] } {
  28         set _CPUTAPID $CPUTAPID
  29 } else {
  30         set _CPUTAPID 0x6ba00477
  31 }
  32
  33 # Enable CPU1 debugging as a separate GDB target
  34 set _ENABLE_CPU1 1
  35
  36 # Musca A1 has 32KB SRAM banks. Override default work-area-size to 8KB per CPU
  37 set WORKAREASIZE_CPU0 0x2000
  38 set WORKAREASIZE_CPU1 0x2000
  39
  40 # Set SRAM bank 1 to be used for work area. Override here if needed.
  41 set WORKAREAADDR_CPU0 0x30008000
  42 set WORKAREAADDR_CPU1 0x3000A000
  43
  44 source [find target/arm_corelink_sse200.cfg]