tcl/board/8devices-lima.cfg

   1 # SPDX-License-Identifier: GPL-2.0-or-later
   2
   3 # Product page:
   4 # https://www.8devices.com/products/lima
   5 #
   6 # Location of JTAG pins:
   7 # J2 GPIO0      JTAG TCK
   8 # J2 GPIO1      JTAG TDI
   9 # J2 GPIO2      JTAG TDO
  10 # J2 GPIO3      JTAG TMS
  11 # J2 RST        directly connected to RESET_L of the SoC and can be used as
  12 #               JTAG SRST. Note: this pin will also reset the debug engine.
  13 # J1 +3,3V      Can be use as JTAG Vref
  14 # J1 or J2 GND  Can be used for JTAG GND
  15 #
  16 # This board is powered from mini USB connecter which is also used
  17 # as USB to UART converted based on FTDI FT230XQ chip
  18
  19 source [find target/qualcomm_qca4531.cfg]
  20
  21 proc board_init { } {
  22         qca4531_ddr2_550_550_init
  23 }
  24
  25 $_TARGETNAME configure -event reset-init {
  26         board_init
  27 }
  28
  29 set ram_boot_address 0xa0000000
  30 $_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000
  31
  32 flash bank flash0 ath79 0xbf000000 0 0 0 $_TARGETNAME cs0