src/target/target/hammer.cfg

   1 # Target Configuration for the TinCanTools S3C2410 Based Hammer Module
   2 # http://www.tincantools.com
   3
   4 #use combined on interfaces or targets that can't set TRST/SRST separately
   5 reset_config trst_and_srst
   6
   7 #jtag scan chain
   8 #format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
   9 jtag_device 4 0x1 0xf 0xe
  10
  11
  12 target create target0 arm920t -endian little -chain-position 0 -variant arm920t
  13 [new_target_name] configure -work-area-virt 0 -work-area-phys 0x30800000 -work-area-size 0x20000 -work-area-backup 0
  14 [new_target_name] configure -event reset-init {
  15         # Reset Script for the TinCanTools S3C2410 Based Hammer Module
  16         # http://www.tincantools.com
  17         #
  18         # Setup primary clocks and initialize the SDRAM
  19         mww 0x53000000 0x00000000
  20         mww 0x4a000008 0xffffffff
  21         mww 0x4a00000c 0x000007ff
  22         mww 0x4c000000 0x00ffffff
  23         mww 0x4c000014 0x00000003
  24         mww 0x4c000004 0x000a1031
  25         mww 0x48000000 0x11111122
  26         mww 0x48000004 0x00000700
  27         mww 0x48000008 0x00000700
  28         mww 0x4800000c 0x00000700
  29         mww 0x48000010 0x00000700
  30         mww 0x48000014 0x00000700
  31         mww 0x48000018 0x00000700
  32         mww 0x4800001c 0x00018005
  33         mww 0x48000020 0x00018005
  34         mww 0x48000024 0x009c0459
  35         mww 0x48000028 0x000000b2
  36         mww 0x4800002c 0x00000030
  37         mww 0x48000030 0x00000030
  38         flash probe 0
  39 }
  40
  41 # speed up memory downloads
  42 arm7_9 fast_memory_access enable
  43 arm7_9 dcc_downloads enable
  44
  45 #flash configuration
  46 #flash bank <driver> <base> <size> <chip_width> <bus_width> [driver_options ...]
  47 flash bank cfi 0x00000000 0x1000000 2 2 0