X-Git-Url: https://review.openocd.org/gitweb?a=blobdiff_plain;f=tcl%2Ftarget%2Fat91samdXX.cfg;h=fb3be04a4b35b568a470abacb6ea6382295b0429;hb=1c021ed0afb5f9f7d9e8cbce53a4fe985a4c2235;hp=0a1ef26c9162d6a1609651c5c687756cd1a68414;hpb=67f664a068238b106249bf33a77a67531bbf3b75;p=openocd.git

diff --git a/tcl/target/at91samdXX.cfg b/tcl/target/at91samdXX.cfg
index 0a1ef26c91..fb3be04a4b 100644
--- a/tcl/target/at91samdXX.cfg
+++ b/tcl/target/at91samdXX.cfg
@@ -40,10 +40,6 @@ target create $_TARGETNAME cortex_m -endian $_ENDIAN -chain-position $_TARGETNAM
 
 $_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size $_WORKAREASIZE -work-area-backup 0
 
-$_TARGETNAME configure -event gdb-flash-erase-start {
-    halt
-}
-
 # JTAG speed should be <= F_CPU/6. F_CPU after reset is 4 MHz, so use F_JTAG = 0.5MHz
 #
 # Since we may be running of an RC oscilator, we crank down the speed a
@@ -54,8 +50,11 @@ $_TARGETNAME configure -event gdb-flash-erase-start {
 adapter_khz 500
 adapter_nsrst_delay 100
 
-# if srst is not fitted use SYSRESETREQ to
-# perform a soft reset
-cortex_m reset_config sysresetreq
+if {![using_hla]} {
+   # if srst is not fitted use SYSRESETREQ to
+   # perform a soft reset
+   cortex_m reset_config sysresetreq
+}
 
-# no flash defined yet
+set _FLASHNAME $_CHIPNAME.flash
+flash bank $_FLASHNAME at91samd 0x00000000 0 1 1 $_TARGETNAME