X-Git-Url: https://review.openocd.org/gitweb?a=blobdiff_plain;f=tcl%2Ftarget%2Fat91sam7sx.cfg;h=20e468999bf0ef521569e800a1847103047320a9;hb=1e07f7bb6a3bb667b5401ffd94ac7985d91fb6cc;hp=f3cc88e99c9625e6bd73b08166c2d596f066ccc5;hpb=2dfa5e9c844a5a3f8aaca146c874f13570b8f667;p=openocd.git

diff --git a/tcl/target/at91sam7sx.cfg b/tcl/target/at91sam7sx.cfg
index f3cc88e99c..20e468999b 100644
--- a/tcl/target/at91sam7sx.cfg
+++ b/tcl/target/at91sam7sx.cfg
@@ -2,18 +2,18 @@
 reset_config srst_only srst_pulls_trst
 
 if { [info exists CHIPNAME] } {
-   set  _CHIPNAME $CHIPNAME
+   set _CHIPNAME $CHIPNAME
 } else {
-   set  _CHIPNAME at91sam7s
+   set _CHIPNAME at91sam7s
 }
 
 if { [info exists ENDIAN] } {
-   set  _ENDIAN $ENDIAN
+   set _ENDIAN $ENDIAN
 } else {
-   set  _ENDIAN little
+   set _ENDIAN little
 }
 
-if { [info exists CPUTAPID ] } {
+if { [info exists CPUTAPID] } {
    set _CPUTAPID $CPUTAPID
 } else {
    set _CPUTAPID 0x3f0f0f0f
@@ -51,6 +51,3 @@ $_TARGETNAME configure -work-area-phys 0x00200000 -work-area-size 0x4000 -work-a
 #flash bank <driver> <base_addr> <size> <chip_width> <bus_width> <target_number> [<target_name> <banks> <sectors_per_bank> <pages_per_sector> <page_size> <num_nvmbits> <ext_freq_khz>]
 set _FLASHNAME $_CHIPNAME.flash
 flash bank $_FLASHNAME at91sam7 0 0 0 0 0 0 0 0 0 0 0 0 18432
-
-# For more information about the configuration files, take a look at:
-# openocd.texi